Keywords

castellatedMesh [boolean]

Flag to run/skip castellation stage

castellatedMesh yes; // no

Flag to run/skip snapping stage

snap        yes; // no

Flag to run/skip layer addition stage

addLayers   yes; // no

Single region surfaces get patch names according to the surface only. Multi-region surfaces get patch name surface "_ "region. Default is true

singleRegionName  yes; // no

Avoid patch-face merging. Allows mesh to be used for refinement/unrefinement. Default is true

mergePatchFaces yes; // no

Preserve all generated patches. Default is to remove zero-sized patches (false).

keepPatches     no; // yes

Merge tolerance. Is fraction of overall bounding box of initial mesh. Note: the write tolerance needs to be higher than this.

Debug levels to write intermediate mesh data. Use debugFlags instead for better control

Example

debug     1;

Provides fine-grain control over the debug output, including:

Example

debugFlags
(
    featureSeeds
    attraction
);

Provides fine-grain control over the write output, including:

mesh: write all mesh information
noRefinement: write mesh without refinement information (level0Edges, surfaceIndex)
scalarLevels: write volScalarField with cellLevel for post-processing
layerSets: write cellSets, faceSets of faces in layer
layerFields: write a volScalarField for layer coverage

Example

writeFlags
(
    scalarLevels
    layerSets
    layerFields     // write volScalarField for layer coverage
);

Would you like to suggest an improvement to this page?

Licensed under the Creative Commons License BY-NC-ND